top of page
Blog
Search
V.L Clark
Oct 3, 20210 min read
3 views
0 comments
Project 5.2: Change LED State by Push Button
With debouncing: Without debouncing (LED gets "confused"):
V.L Clark
Oct 3, 20211 min read
3 views
0 comments
Project 5.1 - Control LED Through Push Button
This is similar to a project in the first chapter. However, here, a digital circuit has been constructed, so the push-button is used as...
V.L Clark
Sep 19, 20211 min read
3 views
0 comments
V.L Clark
Sep 19, 20210 min read
2 views
0 comments
Project 4.1 - Different Brightness
Pulse Width Modulation: PWM uses digital pins to transmit square waves of various frequencies (a wave's frequency is described as the...
V.L Clark
Sep 19, 20211 min read
6 views
0 comments
V.L Clark
Sep 12, 20210 min read
4 views
0 comments
Project 3.1: Ten LEDs
Ten resistors are all 220 ohms.
V.L Clark
Sep 12, 20211 min read
4 views
0 comments
V.L Clark
Sep 12, 20210 min read
2 views
0 comments
Project 2.1: Two LEDs Blink
Black wire is connected to the ground port on the Arduino. Green wire is connected to port 5 and the yellow wire to port four. Both...
V.L Clark
Sep 11, 20211 min read
8 views
0 comments
Breadboard Project 1.2: Control LED By Arduino
This is the first project that involves using the Arduino as more than just a power supply. Here, by holding down the switch, you can...
V.L Clark
Sep 11, 20211 min read
6 views
0 comments
Breadboard Project 1.1.2: LED Controlled By Switch
Positive wire is plugged into 5V output on the Arduino. Negative wire is plugged into the ground terminal on the Arduino. The switch...
V.L Clark
Sep 11, 20211 min read
4 views
0 comments
bottom of page